Skip to content
LocalFixQuotes

Metal Roofing Quotes in Dallas

Free metal roofing quotes

Local pros serving Dallas. Two short steps.

Step 1 of 2

Step 1: your project
How soon?

Free for homeowners. No spam calls. You pick who to hire.

Dallas homes face the full North Texas mix of spring hail, 100°F-plus summers that run air conditioners for months, and the occasional hard freeze that tests heating systems built for mild winters. Metal roofs are gaining ground in North Texas for one reason: homeowners are tired of replacing shingles every hail cycle. A properly installed standing-seam metal roof can outlast three composition roofs, shrugs off most hail, and reflects summer heat. It also costs two to three times more up front, and a bad install is worse than a good shingle roof. We match you with Dallas installers who do metal every week.

Insurance
Liability certificate confirmed
Address
Physical DFW office, not a P.O. box
References
Local jobs from the past year
Limit
At most 4 roofers, never resold

What it commonly costs here. Standing-seam metal roofing in DFW commonly runs $900 to $1,600 per square installed, so $25,000 to $45,000 or more for a typical home versus $9,000 to $18,000 for composition shingles. Exposed-fastener metal panels are considerably less but have a shorter service life and more maintenance. Quotes vary by home and by contractor. That is the whole reason to get more than one.

metal roofing in Dallas

What Dallas homeowners should know before getting quotes

What determines metal roof cost in DFW

Panel type. Standing seam (concealed fasteners, 24- or 26-gauge steel) is the residential standard and the most expensive. Exposed-fastener panels (R-panel, 5V, corrugated) are cheaper but the thousands of screws and washers become leak points over time, especially with Texas thermal cycling.

Gauge and finish. Heavier 24-gauge steel resists hail denting better than 26 or 29. Kynar (PVDF) paint finishes hold color for decades in Texas sun; cheaper polyester finishes chalk and fade. Aluminum and copper are premium options.

Roof complexity and underlayment. Metal is priced heavily on labor. Hips, valleys, dormers, and skylights each require custom flashing. A high-temperature synthetic underlayment is mandatory under metal in Texas heat.

Tear-off vs. overlay. Some cities allow metal over one existing shingle layer with purlins. It saves tear-off cost but can trap moisture and void some warranties. Ask the installer and your city.

Metal vs. composition in the hail belt: the honest comparison

Hail. Metal rarely leaks from hail, but it dents. Insurers often exclude cosmetic damage on metal roofs, so a hail-dented standing seam roof may not be an insurance claim even though it looks bad. Class 4 impact-resistant shingles are the middle option: cheaper than metal, better than standard shingles, and often earn a premium discount.

Lifespan and total cost. A quality standing-seam roof commonly lasts 40 to 60 years in Texas. Over that span it can cost less than two or three composition replacements, but only if you stay in the house long enough. For a 5 to 10 year horizon, composition usually wins on math.

Resale and HOA. Metal is accepted and even desirable in many DFW neighborhoods now, but some suburban HOAs restrict it or specify color and profile. Get written HOA approval before you sign a contract.

Metal roofing in North Texas conditions

Heat. Metal reflects far more solar energy than dark shingles, and light Kynar colors can meaningfully lower attic temperatures and cooling costs. Ventilation and a radiant barrier still matter.

Noise and expansion. Properly installed over solid decking with underlayment, rain noise is not much different from shingles. Panels expand and contract with 100-degree daily temperature swings, which is why standing-seam clips and proper fastening matter.

Installer selection. Metal is unforgiving of sloppy flashing. Ask how many standing-seam roofs the crew installed last year, whether they roll-form panels on site, and for addresses you can drive by. DallasRoofQuotes is a free matching service, not a roofing company; we connect you with independent, insured DFW installers and you choose.

Local notes for Dallas

Dallas housing spans a century: 1920s–40s homes in Lakewood, the M Streets, and Oak Cliff with steep roofs and retrofitted ductwork; 1950s–70s ranch homes across Lake Highlands and North Dallas, many on their third roof and second or third air conditioner; and newer infill builds with modern systems. Mature trees mean roof debris and limb damage, and older attics often have undersized ducts and poor ventilation that strain both the roof and the AC.

Our matched roofers regularly work in Lakewood, Lake Highlands, Preston Hollow, Oak Cliff, and M Streets and across Dallas. If you're in the 75204, 75206, 75214 ZIP codes or nearby, you're squarely in their service area.

How the desk works

Three steps. No phone tag.

No account and no fee. We're paid by the roofers, not by you, and you're never obligated to hire.

  1. Tell us what you're seeing

    Leak, storm, stain, or a roof that's just old. Pick the service, enter your ZIP, say how urgent.

  2. We send it to insured local roofers

    Up to 4 established DFW companies with a real address and references. Not the crew that knocked after the hail.

  3. They inspect, you decide

    Photos of the actual damage, a written quote, and a straight answer on whether it's a claim. You choose who to hire.

FAQ

Metal Roofing questions, answered

How much does a metal roof cost in Dallas?

Standing-seam metal commonly runs $900 to $1,600 per square installed in DFW, or $25,000 to $45,000 or more for a typical home. Exposed-fastener panels cost considerably less but don't last as long.

Does hail damage metal roofs?

Large hail can dent metal, but leaks are rare. Many Texas insurance policies exclude cosmetic damage on metal roofs, so dents may not be a covered claim.

Is a metal roof worth it in Texas?

If you plan to stay 15 or more years, often yes. It can outlast multiple shingle roofs and reduces cooling costs. For a shorter horizon, Class 4 impact-resistant shingles are usually the better value.

Do HOAs in DFW allow metal roofs?

Many do, some with restrictions on color and profile, and a few prohibit them. Get written approval from your HOA before signing with an installer.

Related guides

Before you get quotes in Dallas

All Roofing guides →

Ready for metal roofing quotes in Dallas?

Most homeowners hear from a matched pro within the hour on a business day. Free, no obligation. Only licensed or insured local roofers.

Get my free quotes
Get free roofing quotes